Supported racks and rack options
The frame and support rails are engineered for mounting into a 19 in (48.26 cm) wide front panel, 4-post cabinets, and racks that have been designed according to the EIA-310-D standard.
Hewlett Packard Enterprise rails are not compatible with tapped holes. There are two types of supported rail sets for the frame:
- A set for square-hole front and rear mounting flanges
- A set for round-hole flanges
The rails are compatible with a nominal rack-mounting depth of 29 1/8 in (73.98 cm), with an adjustability range of plus ½ in (1.27 cm) to minus 1 ½ in (3.81 cm). The rails will work in both a 42.32 in (1075 mm) and a 47.24 in (1200 mm) deep rack.
A 42U/47U rack supports up to four frames.
While the square-hole rail set is the standard option, either rail set supports a fully loaded frame weighing 550 lb (249.48 kg). Four of these frames together approach the 2,250 lb (1247.38 kg) internal IT equipment limit of both the HPE 42U x 600 mm x 1075 mm and the 42U 600 mm x 1200 mm 11000G2 Series QS racks.
Cables, PDUs, and other cable management hardware could increase the weight sufficiently to require the use of the HPE 42U x 600 mm x 1200 mm Intelligent Series QS rack, which supports 2,750 lb (1247.38 kg) internal IT equipment.