Installing an SSD module on the M.2 SSD Enablement Board
Procedure
- Power down the server .
-
Remove all power:
- Disconnect each power cord from the power source.
- Disconnect each power cord from the server.
- Extend the server from the rack.
- Remove the access panel.
- Remove the PCIe riser cage.
-
Remove the expansion slot blank.
IMPORTANT: For management and monitoring of the SSD modules, use the HPE Smart Storage Administrator.
-
Install the SSD module on the M.2 SSD enablement board.
- Install the M.2 SSD enablement board in any slot in the primary or secondary PCI riser cage.
- Install the PCI riser cage.
- Install the access panel.
- Install the server into the rack.
- Connect each power cord to the server.
- Connect each power cord to the power source.
- Power up the server .