Replacing Accelerator 2 in a three-slot riser cage assembly
Procedure
- Power down the node.
- Disconnect all peripheral cables from the node .
- Remove the node from the chassis.
- Place the node on a flat, level surface.
- Remove the three-slot riser cage assembly.
- Disconnect the accelerator power cable from the bayonet board.
- Remove the riser cage bracket from the three-slot riser cage assembly.
- Disconnect all cables from the accelerators.
- Remove Accelerator 2 from the three-slot riser cage assembly.
To replace the component:
- Remove the front and rear support brackets for Accelerator 2.
IMPORTANT: Keep these brackets to install them onto the new accelerator.
- NVIDIA Tesla K40, K80, M60, M40, P40, or P100 GPU
- Remove the front support bracket for Accelerator 2.
- Remove the rear support bracket for Accelerator 2.
- NVIDIA GRID K2 GPU
- Remove the rear support bracket for Accelerator 2.
- Remove the front support bracket for Accelerator 2.
- Intel Xeon Phi Coprocessor 5110P
- AMD FirePro S9150 GPU
- Remove the rear support bracket.
- Remove the cover from Accelerator 2.
- Remove the front support bracket.
- AMD FirePro S7150 GPU
- Remove the rear support bracket.
- Remove the cover from Accelerator 2.
- Remove the front support bracket.
- Remove the existing rear support bracket from the new accelerator. Keep this bracket to install it onto the failed accelerator.
- If replacing an AMD FirePro S9150 GPU or AMD FirePro S7150 GPU, remove the cover from the new accelerator:
- AMD FirePro S9150 GPU
- AMD FirePro S7150 GPU
- AMD FirePro S9150 GPU
- Remove the existing front support bracket from the accelerator. Keep this bracket to install it onto the failed accelerator.
- AMD FirePro S9150 GPU or AMD FirePro S7150 GPU
- AMD FirePro S9150 GPU or AMD FirePro S7150 GPU
- Install the front and rear support brackets for Accelerator 2 onto the new accelerator:
- Install the front support bracket for Accelerator 2.
- If replacing an AMD FirePro S9150 GPU or AMD FirePro S7150 GPU, reinstall the cover.
- Install the rear support bracket for Accelerator 2.
To replace the component, reverse the removal procedure.