Cable routing: Smart Array P824i-P Controller
Observe the following:
Do not store excess cabling in the rear of the server. This blocks airflow and increases heat inside the server.
Extra cable slack should be stored towards the front of the server, near the drive backplane.
Backup power cable
A smart storage battery is required with this controller. Your riser might look different from the one shown. To locate a backup power connector, see "Riser board components".
24SFF with a Smart Array P824i-P controller in primary
24SFF with a Smart Array P824i-P controller in secondary
Front 12LFF + Middle 4LFF + Rear 3LFF with the Smart Array P824i-P in the primary position
*One cable is left disconnected.
Front 12LFF + Middle 4LFF + Rear 2SFF with the Smart Array P824i-P controller in the primary position
*One cable is left disconnected